01Upload your 3DGS data
If the mesh does not come out well (capture tips)
Whether a scene can become a mesh depends far less on the conversion settings than on how the original 3DGS was captured. When we looked into the data that did not work, it was always one of the following.
- Surfaces you did not capture cannot be filled.An object never seen from below loses its bottom, and a building circled on one side only has no back.Go all the way around the subject, at more than one height, when you capture.
- Fur, leaves, thin wings and hair do not become surfaces.Plush fur and plant leaves look like mist in 3DGS and melt when a surface is stretched over them. If the outline is enough, use “Prioritize hole filling”; if you need the shape, rather than recapturing it is quicker to try a different subject.
- Sparse points do not become surfaces.If the preview is so sparse that you can see through to the other side, train for more iterations or recapture from closer and the result will change.
- Remove unwanted surroundings first.Points floating in the sky or a wide stretch of ground pull the shape toward them. Use “Crop / remove extras” to keep only the subject.
After uploading, a preview of the original 3DGS appears on the left. Parts that look missing there will not be filled by the conversion.Please check it first.
Saves an STL scaled to the given size together with the inspection report. The original GLB is not changed. Check thickness, self-intersections and bed contact in your slicer.
Compare with the original / check from 6 directions
Switches between the original 3DGS points (simplified) and the converted model at the same camera position. Splat extent and opacity are not reproduced. In overlay mode the converted model is semi-transparent.
To check in Blender as well, choose “Blender comparison set (ZIP)” as the download format.
Upload your data from the left panel and start a conversion